When changing over to Image Armor inks and to achieve the BEST results make sure that you do the following:
CLEAN your printer by flushing the entire lines, printheads, etc with IMAGE ARMOR™ PRINTER CLEANING SOLUTION. The user manual for your specific printer should have instructions for performing a system flush.
DO NOT USE THE PRINTER CLEANING SOLUTION FOR LONG TERM STORAGE OF YOUR PRINTER. IT CAN RESULT IN DAMAGE TO YOUR LINES AND PRINTHEADS.
The CLEANING Solution is fine for flushing the old inks from your printer and then loading the E-SERIES inks back into your printer. Do a couple of head cleanings or test prints to ensure all CLEANING Solution is vacated from the print head before starting any production runs.
NOTE: Perform a print head nozzle test BEFORE changing out your legacy inks to Image Armor. If you have missing nozzles it is likely that you will still have missing nozzles once you have swapped out the inks. The Image Armor Cleaning Solution used during the flushing procedure may, as a side benefit, clear some blocked nozzles, but neither it, nor the Image Armor inks, are a “magic bullet”.
ONLY use Image Armor E-SERIES™ Inks as a complete set in your printer.
We do not recommend or suggest inter-compatibility with other DTG inks. Mixing inks can result in poor wash ability, coverage, adhesion, etc. Image Armor not suitable for Viper 2.
Use only Image Armor™ Pretreatments for best results. Other pretreatments are not recommended and can severely affect wash durability, adhesion, vibrancy, etc.
See more about Image Armor
Image Armor Inks and Pre Treats / Image Armor Ink / Image Armor Pre Treats / Using Image Armor Pretreat / Discover Image Armor Inks and Pre Treats
Order a Starter Pack at email@example.com